Cup to Cup GBC module Type2

Started: July 2017 Completed: July 2017 Released: August 2017
P1701125mcP1701036mc The “Cup to Cup GBC module”, which has been one of the regular modules at the GBC exhibition I have been associated with since 2011, now has a sister module. Surprisingly, the hollow curve of a light reflector fits the gibbous curve of a soccer ball perfectly, similar to a socket and bulb. A set of three silver light reflectors received the balls; in the next moment, the balls were received by another set of three silver light reflectors. The Cup to Cup module transferred the balls horizontally; the new module transferred them vertically. This is the evident difference between the two models. P1701080mcP1701053mc The two different mechanisms generating the up-and-down motion and the tilt motion of the cups are separately located in the rear and both the sides of the module, respectively. The mechanisms are combined to achieve a series of cup movements to transfer the balls vertically; first, the forwarding cups containing the balls exert a lifting motion, and subsequently tilt by a large degree and empty the cups into the cups in the next position, which tilt slightly to receive the falling balls. The mechanical structure of the vertical transfer in the new module is slightly more complex than that of the horizontal transfer in the Cup to Cup GBC module, and it is difficult to adjust the phases of the gears in the new module. P1701140mcupP1701149mc The input part of the new module employs a shortened version of the stepper used in the Cycloidal drive GBC module. An extensive amount of time was required to construct the mechanism to transfer the balls from the stepper to the first cup. The output part of the module uses the “Snake Slide”, the output part of the Fork to Fork GBC module. The Snake Slide has superior flexible connectivity to the subsequent module. My recent modules also employ the Snake Slide. P1701223m2P1701220m2 I would like to explain the engagement of the 40-tooth and the 20-tooth gears in this model. The axle distance between the two gears should be 3.75 stud. In this model, the bent lift-arms were used to engage the two gears by a distance of 3.69 stud (see left figure). The distance of 3.69 stud is slightly shorter than expected. Consequently, depending on the variability of the two gears, they are not able to engage smoothly with each other. As a solution, the double 20-tooth bevel gear could be replaced with two single bevel gears (see right figure). P1701194mc2 The new module was constructed to occupy a smaller space with regard to the neighboring modules at the GBC exhibition. In future, I want to place a larger number of modules on each table and organize a dynamic GBC exhibition. The working of the module is smooth and stable, while the balls occasionally fall from the cup when the motion of the module temporarily ceases. P1701002mP1701170mc P1701180mcP1701171mc P1701159mP1701085mc P1701138mcP1701131mc P1701121mcP1701118mc
08/16/2017